blouse

1°step: pattern according to drawing

2°step: in calicot

feedback:
-I have to make a seam under the boobs, where the edge of the trousers will stand, to have the desired fluidity of the top part and the fitting around the waist which will be under the trousers. The belt will be made in only one fabric while the top part will need 3 layers.
-the blouse will be closed with a zip at the side seam.
-need to make a toile in a fabric that is closer to my chosen fabric (chiffon)

3°step: 2°toile:

 

feedback:

-my model couldn t move her arm properly. so I had to put the sleeve higher on her arm and change the patterns.

-I will need to saw the 3 panels together at the sleeve.

-for the finition, I have differents options. I can make every layer doubled or do a gumping overlocking. I choosed the second option as I think the first one may reduce the fluidity that I want for my top

-the zip will be under the left arm as it will be easier to put it in than if it was on the right arm.

4°step: 3° toile

feeback: 

-patterns are good. the model can move her arm.

-After a test, I noticed that the gumping overlocking take a lot a fabric in the seam. Therefore, I need to consider this fact when I m cutting the panels in the real fabric: leave a seam allowance of 5 mm at the edge that will be taken in the gumping overlocking.

5°step: FINAL  FABRIC